광섬유센서

Web site : https://www.philtec.com

A1 - (Analog) Provides temperature stabilized electronics for low drift and high accuracy.

A2 - Provides low speed analog output for muDMS sensors with USB output.

G1 - Additional output, DC coupled with 10x gain and adjustable DC offset.

G2 - Additional output, AC coupled with 10x gain.

G3 - Additional Output, Binary TTL Output, 0/5 volts.

H1 - High frequency amplifier for D models up to 200 KHz bandwidth.

H2 - High frequency amplifier for D models above 200 KHz to 1 MHZ bandwidth.

H3 - Provides RC models with a high bandwidth amplifier,DC – 200 KHz.Bandwidths up to 350 KHz can be specified.

+H1 - Additional output for D models with bandwidths up to 200 KHz.

+H2 - Additional output for D models with bandwidths exceeding 200 KHz up to 1 MHz.

+H3 - Additional high frequency output.

L- Low frequency amplifier (< 20 KHz), 100 Hz STD.

+L - Additional output with low frequency bandwidth (< 20 KHz), 100 Hz STD.

M - Digital display – DC volts.

N - Low Noise Amplifier – The amplifier is optimized to operate with highly reflective targets only. This cuts noise floor in half, thereby doubling resolution (For RC sensors only)

O - Provides an adjustable 0 to -4 VDC offset control. This feature is used to eliminate the DC offset from the sensor output, thereby increasing readout resolution.

P - Polynomial curve fit to specified calculation range

Q - Connectorized AC/DC power adaptors and BNC outputs for 1, 2 or 4 sensors.

R1 - AMBIENT LIGHT REJECTION – STANDARD UNITS ARE SENSITIVE TO BROADBAND LIGHT FROM 400 – 1100 nm. WITH OPTION R1, INCOMING LIGHT IS BLOCKED FROM <800 to >900 nm.

R2 - BLUE LIGHT FILTER, 470 nm ±50 nm.

V - Provides sensor amplifier with 0 – 10 volt output.

Z - Additional Output with Linear Range Spanning 0 – 5 volts